rb26 gears in z32 center and rear half

[85gtr720]

i have taken apart my my rb26dett transmission and did a bell housing swap but i am wondering if it is possible or worth changing all the gears from the rb26 trans to the z32 all i have really found is topics about rb25 z32 swaps that go that deep in to them

[rbsileighty]

Just want to be clear...

You have a RB26 Bellhousing on a Z32 Trans case correct?

Both are FS5R30A's...

Z32:1st - 3.2142nd - 1.9253rd - 1.3024th - 1.0005th - .752

GTR:

1st 3.214 2nd 1.925 3rd 1.302 4th 1.000 5th 0.752

I understand the input shafts are slightly different in length but not by much with a 25 so I'm not sure about the 26 but wasn't an issue going buy the guy's post below:http://forums.hybridz.org/showthread.php?t=119041

Hope this helps...

[85gtr720]

yeah i have the rb26dett bell on the z32 rear

[85gtr720]

the z32 input shaft is .25" longer then the rb26dett's

[rbsileighty]

Might consider a spacer plate (have one cut with a water jet... shouldn't be to expensive depending on how well you can source the material/labor)... just make sure you have enough thread length and don't make it to thick...

Let me know if you need help finding a water jet or material...

[85gtr720]

we don't have a watter jet around where i live the only way around here is a cnc plasma would that work. what would be the best meterial

[240z4u]

the input shaft thing has been covered 10x over.

Just bolt it together and be done, its no big deal.

Evan

[rbsileighty]

Good to know... who's using this setup at the moment? I've been out of the loop for a while...

[Booztd 3]

the input shaft thing has been covered 10x over.

Just bolt it together and be done, its no big deal.

Evan

LOL

I cant count with my fingers how many times I've had to stress that........

[Booztd 3]

Good to know... who's using this setup at the moment? I've been out of the loop for a while...

I have, for years now, and it works fine

[85gtr720]

does anyone know if you can convert the 300z shifter to the rb26 style shifter

[Booztd 3]

does anyone know if you can convert the 300z shifter to the rb26 style shifter

Not if you keep the same tail section on........the linkage setups are completely different