rb25 rebuild

[until240]

i know this is a common question on this and other boards, and i've been reading everything i could find. however, i just want to make sure that i'm not missing anything. i am getting my rb rebuilt (series 1), and here is what i'm getting done:

-cp pistons, overbore-cosworth hg-arp headstuds-acl race bearings-greddy timing belt-tomei poncams-n1 oil and water pumps-welded crank collar -balance rotating assembly

in terms of goals, i'm looking to build a bulletproof engine that can handle 450whp+, at least 22psi, and last me at least 5 years...or is this too optimistic? lol. anyways, any info you could throw my way would be much appreciated.

[Coolwhip]

main studs, and especially rod bolts.

If your looking for a set of CP Pistons I got a new set I'll sell you, email me at Coolwhip(at)tmail(dot)com

[Darius]

Be very careful to weld on your crank because someone just did that recently and warped it turning their crank a 30 lb dumbell. Otherwise I like the parts selection.

[until240]

Modified by until240 at 4:24 PM 11/30/2007