rb25 lsd into s13
-
deez_lug_nutz
- Posts: 2
- Joined: Sat May 28, 2005 9:12 pm
- Car: 93 240sx coupe
rb25 lsd into s13
I have recently bought a lsd from a rb25 and the bushings are missing! Ive looked all over and i cannot find the bushings anywhere!
-
deez_lug_nutz
- Posts: 2
- Joined: Sat May 28, 2005 9:12 pm
- Car: 93 240sx coupe
Re: rb25 lsd into s13 (deez_lug_nutz)
is it the same bushings that is in the z32 300zx and s14 r200?I dont think its the viscous! does that mean the final drive is to high?
Re: (SmithSR)
Are you talking about the shims that go on either side? Try using the ones from your stock diff, make sure the larger shim stays on the same side and run a pattern on the ring gear. If its not meshing on the center of the ring gear forget my sugestion, you may need different ones. I have never tried re-shimming vlsd's, just clutch types, obviouslly if it doesnt seem right then dont try and run on it.
As far as the final drive, you may have to swap ring gears and use the original one from whatever pumpkin you will be using.
As far as the final drive, you may have to swap ring gears and use the original one from whatever pumpkin you will be using.