rb20det swap into 240sx

[RB20DETownz]

after buying the motor what goodies will i need to buy to get the car running properly. the motor come with.....Complete Motor Turbo Block Intake Manifold Complete Head Sensors Exhaust Manifold Fuel Rail Injectors Distributor Throttle Body Alternator Starter Ignition Wires Power Steering Pump ECU Complete Wiring Harness 5spd RWD Transmission & Igniter

Is there anything that i will need to get this show on the road??? thanks or the help.-james

[rotorimp]

Hello--Welcome to the Forum--Looks like your missing a couple things--You need to figure out how your going to mount it in the car--motormounts. I would get a one piece drive shaft made. You will need to fab/find a down pipe and find a intercooler. Look in the Engine forums under RB--there is enough expertise and FAQs to get that thing going in no time.

Good to see another person has found the right motor for their car!

[Sil240]

Welcome to NICO.

Checkout the stickies at the top of the page.They will help you out tons.

And pretty much a list of stuff you'll need and how to do it.

[RB20DETownz]

umm i was also thinking about a ca18det swap and i want to know if the sr20 smic with fit with the ca18?? and do sr20 motor mounts work with the ca18??? -thanks 4 the help

[Sil240]

I would check the CA forums.But from what I know KA, CA & SR all use the same mounts.

The Side mount should work but its tiny..Why dont you go for a FMIC?If you want a bigger side mount go for the RB side mount.

[RB20DETownz]

i was just thinking to use a smic for a lil while just to get the swap going and then upgrading to the fmic

[rotorimp]

The only benifit to the ca woould be cost and ease of installation. Stick with the RB!