rb20 swap.....idle and throttle problems

ONLY for ADVANCED technical discussion about the 240sx!
mopar_nismo
Posts: 2
Joined: Thu Feb 25, 2010 6:59 pm
Car: 1990 240sx rb20 swap

Post

hey guys im new to the site.i just got done putting rb20 into my 90 s13. it starts up just fine, yet the idle is up and down up and down and soo on. plus when i give it throttle it will rev up just a tad and then bog out and then rev and bog out again..... if i hold throttle wide open it will do same like revup up then stop and then rev up to same rpm's again and stop then rev up to same and so on and on can anyone give me some advice would be realy apreciated thanks guys im desprite to drive it lol


User avatar
OutToWinPAHC
Posts: 8810
Joined: Thu May 31, 2007 12:19 pm
Car: 2015 Chevy Silverado
Nissan Skyline R33 GTS-t
Nissan Skyline R32 GTR
Nissan RB20 E46 RHD
2015 Harley Vrod Muscle
1990 Nissan Patrol
Location: PA
Contact:

Post

I don't know RB's at all but it sounds like one of 3 issues

FPR lowBad 02 sensor or just bad AFRBad air meter (map or maf)

User avatar
ShouldaHadaV8
Posts: 365
Joined: Sat Oct 10, 2009 7:00 pm
Car: 92 hatchback 240sx, j30 diff, TIEN tie-rods
Location: N. FLA

Post

Make sure the throttle cable has been adjusted to where it needs to be... i ahd same problem with my ka swap it was just the cable and the IACV. took forever to figure out but then again i dont know RB's either

mopar_nismo
Posts: 2
Joined: Thu Feb 25, 2010 6:59 pm
Car: 1990 240sx rb20 swap

Post

alright thanks guys let let u guys kno whats goin on


Return to “240SX Technical Forum”