rattling license plate

[ja105ny]

sorry if anyone asked about this but i couldnt find it. i put a 10" sub in the trunk and my license plate frame and the plate itself rattles like crazy. any suggestions to make it stop? it bothers me like crazy.

[srwong]

i took the frame off, and just put double sided tape behind the plate... works perfect, i have 2 10's

[08Coupe]

My Plate rattled when I shut the trunk and I got a little piece of sound deadener from the install boys at Best Buy (free) and put it on the back. Problem sloved!

[SniperJoe]

Same thing ... took my plate off & sandwiched foam tape between the frame & plate & also applied some between the plate & trunk. No rattles.

[zilla19]

i took the frame off, and just put double sided tape behind the plate... works perfect, i have 2 10's

+1

[bthsburgess]

Step 1. Go to your local shop.Step 2. Give them $5 for half a sheet of dynamat.Step 3. Cut to form.Step 4. Place license plate face down, place dynamat on top, beat with rubber hammer to form.Step 5. Tape dynamat to license plate. (Don't use any glues, or the state will get pissy when it expires.)Step 6. Screw back into place.

[Mattv609]

Step 1. Go to your local shop.Step 2. Give them $5 for half a sheet of dynamat.Step 3. Cut to form.Step 4. Place license plate face down, place dynamat on top, beat with rubber hammer to form.Step 5. Tape dynamat to license plate. (Don't use any glues, or the state will get pissy when it expires.)Step 6. Screw back into place.

and also go to home depot and purchase thick Foam tape and just out put that on the bottom of th pate where theres not screws, and screw it on. hes wat im talkin about on home depot:

http://www.homedepot.com/h_d1/...10053

[Mattv609]

Step 1. Go to your local shop.Step 2. Give them $5 for half a sheet of dynamat.Step 3. Cut to form.Step 4. Place license plate face down, place dynamat on top, beat with rubber hammer to form.Step 5. Tape dynamat to license plate. (Don't use any glues, or the state will get pissy when it expires.)Step 6. Screw back into place.

and also go to home depot and purchase thick Foam tape and just out put that on the bottom of th pate where theres not screws, and screw it on. hes wat im talkin about on home depot:

http://www.homedepot.com/h_d1/...10053

[Mattv609]

Step 1. Go to your local shop.Step 2. Give them $5 for half a sheet of dynamat.Step 3. Cut to form.Step 4. Place license plate face down, place dynamat on top, beat with rubber hammer to form.Step 5. Tape dynamat to license plate. (Don't use any glues, or the state will get pissy when it expires.)Step 6. Screw back into place.

and also go to home depot and purchase thick Foam tape and just out put that on the bottom of th pate where theres not screws, and screw it on. hes wat im talkin about on home depot:

http://www.homedepot.com/h_d1/...10053

[migs7585]

i had two 12 alpines in my 97 altima....the whole car shook, i put double sided tape everywhere lol...works great!