Quick question about a harness!

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
User avatar
Danny240
Posts: 19
Joined: Fri Jun 04, 2010 12:57 pm
Car: 91 240 hatch

Post

I'm swapping my 91 hatch with a blacktop sr20, i pulled the the ka out and sold it already. I sold the motor with the main harness, but what i didn't realize is that i needed some connecters to complete my sr swap. i found a junk yard that will let me pull whatever i need but i was wondering if all 89-90 dash connecters are the same as the 91-94 because at this yard they only have 89-90 models.


User avatar
zachattack_5491
Posts: 641
Joined: Sun Jul 13, 2008 8:00 am
Car: Pignose S13 Redtop SR
Location: Albuquerque, NM
Contact:

Post

Yes, I believe they are the same.

User avatar
Danny240
Posts: 19
Joined: Fri Jun 04, 2010 12:57 pm
Car: 91 240 hatch

Post

thanks! do you know if they differ from an SE and base model b/c i think i ran into another problem lol. the one on my car is brown and the one i cut is white, they dont fit together and not all the pin outs look the same

User avatar
vocationalzero
Posts: 870
Joined: Thu Jan 24, 2008 9:44 pm
Car: 92 Too For Dee
87 BMW 635 CSi
06 Dodge Dakota Night Runner Edition
06 Nissan Sentra S
Location: Pfllugerville, Tx

Post

89-90 (SOHC) have a different plug (as you found out) you have to get one out of your generation (s13, s14, DOHC, sohc, etc). However trim packages don't matter, as in the SE, base

User avatar
Danny240
Posts: 19
Joined: Fri Jun 04, 2010 12:57 pm
Car: 91 240 hatch

Post

thanks! i appreciate the help!


Return to “SR20DET Forum (rear-drive)”