Question about Clutch Master and Slave Cyl's

Post by **nab911** » Wed May 18, 2005 7:30 am

I am about to do a 5 speed swap and instead of buying that hard line and getting a small stainless to route to the slave im going to order a custom stainless line to go from the master to slave cylinders. BUT, i need to know what the fitting sizes are on the master and slave cylinder so i can get the right ends.

Post by **nab911** » Thu May 19, 2005 6:43 am

Well i pulled a piece out and measured it. I ordered a 6 foot stainless braided ptfe smooth bore hose from MC-Master Carr for $33 shipped. I got 3/8" ends so ill just have to pray it fits. If it does ill let yall know because this would be the best alternative Than buying just the small stainless piece.

Post by **slc240sxse** » Thu May 19, 2005 5:20 pm

**** yea dude. Let us know, because I am about to do the same thing on mine.

Post by **xsblacksx** » Sat Feb 25, 2006 10:37 am

no inof.

Question about Clutch Master and Slave Cyl's

Question about Clutch Master and Slave Cyl's

Re: (nab911)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums