ps line

[Disturbe240]

ok i know wen doing en sr swap in a 90 240sx you need the hight presure ps line, if i go to some place like napa and ask them a 240sx hignt presure ps line will i get all i need beacause ai cant find them used local.

thx guys

[C - ROD]

yea, i ordered a 93 high pressure line, just remove the old one from the rack right were the steering shaft comes in at, then install the new one in the rack & it should just loop up to the pump & there is a bracket that holds the line to the tension rod bracket, also have to install the high pressure switch into the line & run the wires over to the other side of the engine bay to the sensor, this is to idle the car up while turning the wheel at a low RPM, i did not have mine hooke up & the idlle didnt drop that much but i would hook it up anyways

[Disturbe240]

thx c-rod

[C - ROD]

no prob