Power Steering hose: how to remove?

[Mopar]

Hi all,

I finally had time to pull out the Q and look where the damage is (It has been leaking PS fluid). Turns out there is a hose that is broken. Fine, I will change it, but am having a hard time figuring out on how to take it off?. I found a small pic of it in the FSM so you guys will have an idea of what I am talking about. here's the pic with the part circled in red

[maxnix]

Feed hose from the reservoir?

[Mopar]

no Maxinix not the feed tube.

There's one at the top of the pump and goes down somewhere. It never connects to the reservoir.

[maxnix]

If it is the large one, that is the low pressure one to the rack. Fittings just use a wrench, I think. I had the tech replace it when the new rack was installed.

Ooops! That was on the G50. Much the same for the FGY33, I am sure.

[Mopar]

it is a large one that goes down to the rack. What might it be called? I called IOS Joe and our local Infiniti dealer and they all want the exact name of it.

[Mopar]

Here's couple of pics of the hose in the Q. It's the big one in the "middle"

[Mopar]

Never mind I found out the name of it. It's called Power Steering Pressure Hose that comes with the assembly. I was quoted 177 bucks from IOS. Ouch!

[Q451990]

You can always opt to have it rebuilt by a local hydraulic hose repair place... I have an old thread here somewhere on my expereince.

Heath

[Nespi13]

Old topic but I need help getting the power steering hose out replace the pump and found a bad line that goes to the rack and pinion I can't seem to free it from the cross member it seems to be stuck? Do I need to drop it an inch to get to it? Please help BTW I'm new to this page

[Nespi13]

Bump please help