Plenum spacer install

[g35sedanlover]

I purchased a Blox plenum spacer and it did not come with directions. I was wondering, do I need 2 more gaskets (one for above and below the spacer) or does the polymer spacer act at a gasket its self? What do your instructions say to do (Skunk2 and MotorDyne guys)?

)
Modified by g35sedanlover at 8:55 PM 12/19/2007

[RED_DET]

The motordyne comes with a gasket.

[g35sedanlover]

1 or 2? If you only get one, do you use it above or below the spacer?

[RED_DET]

1 gasket, goes on top of the spacer.

while i got you on here, what type of sedan do you have. do you know if you have a vlsd? can you write down the number under the hood on the vin/engine/trans axle code. FS6R31A RC35 is the number on mine, i have a vlsd, trying to see if those numbers different for cars not equipped with vlsd.

[RED_DET]

ok, i'm dumb i see what your car is in your sig, you dont have vlsd, can you give me that number.

[g35sedanlover]

no prob, I will try to remember to look tomorrow.

[joe603]

Ummmm guys, the spacer IS the gasket! (use gasket sealer if you're paranoid) The only gasket you have to replace is the lower plenum gasket with the MREV2 replacement...

[G_whizz]

This is what you should have received..

http://motordyneengineering.co...5.JPG

Click here for instructions

http://motordyneengineering.com/manual.htm

Good luck!