Ok sorry for the odd question here it goes. I am slowly but building a vg36 for my z31. I have my block bored to 96mm. Using vg30dett rods wrist pin size is .866 in or 22mm (same as vq35) I was looking at custom pistons but after looking around I got the idea of using 350z pistons. Since I can get them in a 96mm bore, I was thinking easier to replace them/rings etc. If I go with custom I will have to get custom wrist pins then im looking at quite a bit extra plus a good wait. I have the majority of it figured out. Just need to know the wrist pin to dome height on stock pistons.