yah so i need to see if it is somewhat going to fit. curious if anyone can measure the motor length, or if someone has an extra crankshaft lying around, that would be a basis for the measurement, and the distance from the lowest part on the oil pan to the top of the intak piping. and the distance from the highest part on the oil pan to the intake piping....any help would be greatly appreciated. thanks
steve
physical size of an rb20, rb25
-
Nameless EJ6
- Posts: 1228
- Joined: Sun May 11, 2003 9:24 pm
- Car: What the **** do you think.
Re: physical size of an rb20, rb25 (sclay115)
Did you just hear about the RB swap today? It fits.
-
Nameless EJ6
- Posts: 1228
- Joined: Sun May 11, 2003 9:24 pm
- Car: What the **** do you think.
Re: (eh?)
True, that slipped my mind..
Re: (Nameless EJ6)
yah it's not even close to being a 240. but hey do you know where those dimensions are measured from? are they the largest possible points? dimensions as if it were to be shipped in a crate?
Re: (sclay115)
Ok well i got some measurements for you, understand that they could all be off up to an inch or so they are just approximate mesurements. But they should give you an idea. And this is for an Rb25
Width: (from back of intake manifold to wastegate/turbo sheild) 25 inches
Length: (from back of head to pullies) 30"
Height: (from bottom of oil pan to top of intake pipe going over valve cover this one im not 100% on because i had my mother help me with making sure it was level with the intake pipe) 24"
Oil pan height: 4.5"
Width: (from back of intake manifold to wastegate/turbo sheild) 25 inches
Length: (from back of head to pullies) 30"
Height: (from bottom of oil pan to top of intake pipe going over valve cover this one im not 100% on because i had my mother help me with making sure it was level with the intake pipe) 24"
Oil pan height: 4.5"
Re: (dekand)
dude you rock time to bust out the tape measure on my own now...dekand wrote:Ok well i got some measurements for you, understand that they could all be off up to an inch or so they are just approximate mesurements. But they should give you an idea. And this is for an Rb25
Width: (from back of intake manifold to wastegate/turbo sheild) 25 inches
Length: (from back of head to pullies) 30"
Height: (from bottom of oil pan to top of intake pipe going over valve cover this one im not 100% on because i had my mother help me with making sure it was level with the intake pipe) 24"
Oil pan height: 4.5"