Parts Universatility

[cheezball1257]

I have an A/C with the 2.5S Nissan uses that same motor in alot of there vehicles such as the sentra SE-R. If i were to purchase cams and headers for the sentra SE-R and actually put them in my car what would be the actuality of this working? Would it be a matter of the bore itself of the block and dimensions?

Thanks All!

P.S.- Everyone on this forum has been such a great help with everything. As you noticed i have made a few purchases recently for my car and am working towards more

[dldjros69]

Well for starters im positive the headers will not work from the Ser. Stillen is coming out with headers for the A/C shortly. So wait patiently til they come out, ive been waiting for ages.

The cams should work, i have not heard of anybody on this forum putting cams on their 2.5. I also read at the jwt website that the cams give 8 hp, i could be wrong but for 5-600$$$ im not sure that is worth it. the cams will void your engine warranty.

[cheezball1257]

I didn't get an extended warranty or anything so my warranty is just about up in another few thousand miles actually haha

[dldjros69]

http://www.jimwolftechnology.c...D=434

there ya go

and i suggest the new springs too, and bully dog tunning. That way you can rev to 7200 rpms. i bet you could get a sick amount of power out of that.

Maybe 20 since they say the cams only produce 8hp.

I doubt this is a DIY, i love to see this happen

[cheezball1257]

I def might get the new cams. I was looking around at performance chips and programmers as well. I found a site with piggy back systems for like 80 bucks that apparently are designed specifically for w/e car when you order it. I am also looking at bullydog performance programmers. With a chip, cams, and a programmer i can get an additional probably 70+ horsepower which would put my power at the same as the 3.5L without forced induction. Talk about badass!