only getting spark in cyl no 1

[RobDET]

i hard wired my ecu for the time being. Now i'm only getting spark to no1 cyl. Any ideas?

[Samabra]

Hard wired what? What exactly did you do? Cause there are a couple of reasons that could be it Chris

[GodzillaFan]

J4 ECU??

[Cyberkreig]

You have a mis-matched Ecu/wiring harness. Most likely a Type X ecu with a standard harness. Check my website for compatibility list. Look into exchanging your ecu.

[RobDET]

<goob>

hey i have an e6 ecu... sitting in my garage!!

Did i mix them up?

</goob>

[RobDET]

the answer is yes... is STARTED AND RAN FOR AT LEAST 10 SECONDS!!!! (then i killed it cause i didn't want to wake everybody up)

I still have no power to the ecu however. When i feed it direct 12 volt power (to the black wire with a white line in the grey plug by the batt) it runs smoothly.

Any ideasSO close i can taste it!