on my way to the rebuild

Post by **240sxbobbis** » Tue Nov 18, 2008 7:36 am

so i have me here a lil rb20det and im rebuilding it now blew my ca and swapped in an ka and rolling around with that for now but anyways i did my research and didnt find all but a couple things .ie; any one know where and intake manifold can be located not the stock one2. also what is the most you can bore the block out to i was thinking 86.0mm is it possible?

forged pistons at an decent price i was looking at mahle what are the views on them ? what is your rb20det build like ?

Post by **Coolwhip** » Tue Nov 18, 2008 8:39 am

we have a custom RB20 intake manifold in stock. http://shop.rawbrokerage.com/p...d=135

For pistons, rule of thumb is to go only to the extent of the repair. So if you only have to go .20 over, then stop there. Just in case you have to rebuild again and can have room to do one more bore size up.

Post by **240sxbobbis** » Tue Nov 18, 2008 9:14 am

bet im down for that

on my way to the rebuild

on my way to the rebuild

Re: on my way to the rebuild (240sxbobbis)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums