Oil pressure switch removal???

[Mikey_ZX]

The wires that connect to my oil pressure switch are chopped and need to be repaired, needed to know what size socket or wrench did you guys use to remove the oil pressure switch from the block or does the wire disconnect somehow away from the switch??? The FSM says to use a sealant when re installing the switch, what sealant do you guys use to install it back to the block??? Any suggestions will be greatly appreciated!

[qship96]

wire should have a plug on end that connects to sensor. No need to remove sensor to repair this,but if you do, be sure to replace it with a brand new one as it is very inexpensive.

[Mikey_ZX]

Thanks for helping me qship96, I was able to repair my wire harness, had to re-solder the connection, it was looking real bad!