Not even sure

[Zippy69]

Ok, bought a "T-25" kit off the bay.Stop laughing!!!Hot pipe of turbo has a funky little three bolt flange with one of the bolt holes a little farther apart from the other two. It is about an inch and a half in diameter. I can make a flange if I have to, but I will still need to make a cone to fit my 2.5" i/c pipe. This is a bottom mount kit and I can't find a two bolt flange for the intake side. I looked in the stuck thread about oil lines but the oil feed was not a 7/16-24 as stated in the thread, it is 3/8-24 and I can't find crap to make this crappy thing go together!!!The mechanics are no problem and I don't mind making a couple of parts, but this was supposed to take 3-4 days and it has been 5 days with at least another 2, (only working on it in evenings) unless I have to order some more sh*t and wait for it to come in.I am not sure how to identify this as a T-25. The only numbers are .87 a/r on the hot side of the turbo.Please, some one help. This is my daily and right now I'm driving my 1999 F-250 super crew 4-door that gets around 10-12 mpg.

[480sx]

Good luck with that kit...

Sounds like you need a sr20det turbo inlet flange, you can pick them up in the classifieds.

[Zippy69]

Thats what I was thinking, but what about the three bolt outlet?

[Florida240sx]

pics?

[Zippy69]

Can't get pics off of phone. Anybody else have an idea about the outlet on the turbo? Or the three bolt flange with one bolt hole farther away from the other two? How about the size of the oil line fitting at the top of the turbo.I think it is like a 12 or 13 mm BSPT but I can't seem to be able to find out.Anyone?

[480sx]

Its most likely the SR outlet flange, you just need one of those. You can get them on ebay for pretty cheap.

[Zippy69]

Thanks guys,I'll check ebay and see what turns up. I didn't have much luck with that search on ebay the other day though, but I'll try again.