No power to Receiver Unit after instal..

[BabyboyDeLa240]

Just installed a double-din unit. Tried it for the first time, worked fine..as i moved the parts back into place, i guess wires were moving around the power came off. I unplugged everything, replugged the unit to see it working fine again. So I figured wires had gotten loose. I placed the entire unit back into place..again there is no power going to the radio. I tried back the Stock reciever and that too had no power coming to it. Checked the fuse Box under Audio and looks fine. I am using the wiring harness from Crutchfield and taped off any unused wires. What could cause this problem and how do I get the system to power up again? Thanks

Car is a 350z 2004 non-bose non-nav system.Receiver is a DDX6017 in-dash screen
Modified by BabyboyDeLa240 at 1:04 AM 8/21/2005

[Rex]

There should be a couple fuses (both central fuse panel & wiring harness) try them all and see. Do you have a 12 volt source you could bench test using?

[xekushnr]

try the fuse on the back of your double din. it may be blown.

[BabyboyDeLa240]

Thanks you all. It was a fuse, located under the hood. What a relief.