New Hatch

[Tsukai240]

i just got a new hatch from a salvage yard. 155 instaled with exchange. its nice and clean. no rust and no crapy bubbled up tint. the only problem is that it sits a lil crooked. the gap is about 10mm on the left side on the bottom and tight on the right side. i can't see how it would bee so off. any sugestions for a noob.

[Bruno240]

there are little rubber knobs you can twist to raise or lower how your hatch sits. You can fiddel around with those and that might help.

[Tsukai240]

actualy i ment that it is cocked to one side. the hight is good. i think i need new hinges

[silencer.1]

Up where it is attached there are 2 hinges. Loosen the bolts a bit and scoot it how you want it. After that, tighten them back down and you'll be good to go. Might take a little trial and error.