I sold my ka24de (was gonna replace it for a ca18det), but the guy who bought the KA couldn't get it up and running. So he borrowed my loom to check for any differences. He promised me not to cut in it, so I could put it in the vert again without problems. I wasn't gonna work on the vert for a couple of months so I had no problem with it.
When I finally got it back it was a big mess. I was in the middle of moving to another house, so I didn't have time to check if it still worked. Well, it missed a couple of connectors en was cut in multiple places..
I just put in a ca18det in my vert and because of the all f*cked up vertloom I decided to go with an all european loom from a ca18det 240sx (200sx called in europe). It now starts and runs perfectly, but offcourse there are no connectors for the rear windows and top.
I now extracted the vert specific loom from the original loom to integrate it in the ca18det loom.
So, my question is: Can anyone tell me where to connect the following wires to? I checked the verts manual, but I can stare all day to the pictures.. I just don't understand the schemes! I thought it would be easier.
Top switch wires:
red/blue
red/yellow
green/orange
(also blue and yellow , but they go into the vert loom)
other wires:
green (thick)
blue(thick)
blue/red (thick)
black/white (thick) 3x
red/ white stripe
white/ red stripe
red/black stripe
blue/white stripe
black (thick). probably ground
blue/black stripe (thick)
blue/black stripe (thin)
I really hope someone can help
