Need some quick measuring help from my Z32 bretheren!

[2_Liter_Turbo]

I don't have access to a Z32 at the moment, and I would like to request assistance from anyone who has a set of calipers and a jack to please measure a few things for me You would be totally awesome for helping me out!

I need to know the gap above and below the rear differential mounting tabs to the subframe surface (above) and the diff cross member (below). Basically I need to know how thick the factory bushings are. I would also like to see if I could get the bushing diameter measured.

I would really appreciate the help! Thanks

[NolimitZ32]

Could you mark up a picture and post it so I know exactly what measurements you need.

[2_Liter_Turbo]

No problem, I appreciate the help!

I need both "X" and "D" for both bushings

[NolimitZ32]

Gotcha, I'll try to get these dims for you today.

[2_Liter_Turbo]

Awesome, thank you!

[NolimitZ32]

Didn't have a chance to get the car in the air last night. I'll see if I cant get it tonight, may have to wait for the weekend.

[2_Liter_Turbo]

Hey man, did you get a chance to take a look at those bushings?

[NolimitZ32]

I am so sorry, since we had this conversation I have been going through an immense amount of BS including losing my job (funny enough I got laid off on the 12th and haven't been on here since). I'm setting the alarm on my phone right now to get this measured tomorrow.

[2_Liter_Turbo]

No worries man, I'm extremely sorry to hear about your job loss! I appreciate the help!

[NolimitZ32]

Yeah its all good. I pm'd you the measurements and ill post them here for duture reference.

Top 12mm x 60mm
Bottom 7mm x 52mm

[2_Liter_Turbo]

Thanks man, I really appreciate it!

[NolimitZ32]

No worries, let me know how the project goes.