need some advice on my s15

For the RWD SR20DET cars! Sponsored by Wiring Specialties.
MikeDombeck
Posts: 174
Joined: Mon Feb 06, 2006 5:33 am
Car: 1995 Nissan 240sx SE S15 SR20DET

Post

ive modded the engine more than i was planning, and i was wondering how much power the stock internals can handle.... so far my setup is as follows.

Walbro 255300zx BrakesGreddy MSPEC FMICGreddy 256-264 camsApexi N1 3 inch turbo back exhaustAEM TRU BOOST boost controller set to 13... max at 13.5 psiGreddy EmanageHKS Fuel railFuel pressure regulator740cc HKS injectorsNOS 50 shot, wet.... not used very often w/ bottle warmer and purge kit.Blitz Twinplate ClutchP2M rocker arm stoppers

my question is.. am i at the point where i should be worried about internals. i am getting it tuned next week for the mods but i am not sure where i am at.


User avatar
CRyan
Posts: 1403
Joined: Tue Dec 21, 2004 6:53 pm
Car: 1997 Nissan 240SX

Post

I myself believe its nothing to fret over - - - Engine I would think would run fine on short runs w/o nitrous. . . With nitrous could be a different story though. . .yes it is only a 50 shot, but I've seen small wet kits dissolve cylinders (But it was a mitsu mirage too ha)


Return to “SR20DET Forum (rear-drive)”