NEED HELP ASAP!!

[T_love]

My backup car's transmission just took a crap and i need to order my driveshaft today.

I have the measurements from the differential to the tip of the splines but the driveshaft shop i'm going through needs the measurement from the differential to the end of the transmission seal. Does anybody know how much the splines stick out of the transmission. BTW this is for a RB25. if possible, can anybody reply before 5p, EST. or else i'll have to wait till monday to order it. If anybody knows or has a good guesstimation please let me know.

Thanks

[shedrifts]

i would wanna say about 3 to 3.5 inches if u have an old driveshaft measure the spline on it that would be your best be but i think mine was around 3 or 3.5 not for sure thew

[T_love]

are you talking about the full length of the spline or the amount that sticks out from the transmission. I need the amount that sticks out from the transmission.

Thanks

[hashiriya13]

The amount will very on each setup depending how you have your stuff installed. The lengths have been posted on here before on some of the different install metheds. I would measure mine but I am like 12000 miles away in Japan. Sorry

[T_love]

Thanks, I got a chance to look at mine. I have to wait til monday to order though. I guess its back on the bus for me