N60 rb20 mafs wiring..

[90240sxca18]

okay i have a rb20, and just got an N60 mafs cause my i had one from my old RB, problem is...the pigtail color's don't match my wiring harness colors for the MAFS.. anyone have the write out for it? i may just un wrap my whole MAFS extension wireing thing and trace it back.

[TwoJayZee240]

I just baught a n60 for my rb25. From a maxima and i had the same problem. The connector was different but i found that the signal, power, and ground wires are in the same spot regardless of color. I wired the wires the same way the original was. For example... forget the color of the wires and Wire it up the same order the wires are in on the pigtale. make sure to use plents oc electrical tape over the 2 shielded signal wires for no interfearence.

[90240sxca18]

wait, repeat..?

as in, on the stock mafs... say the far left pin for exaple isss black with white stripe, and the one next to it is green... no matter if the n60 pigtail colors are purple and orange wire thtt far left pin to the black and white stripe, and that next one to the green on the harness, even tho they are not color matched? im confused lol.

[placham]

here you go link, should be able to figure it out. http://rbforums.org/pics/NissanMAFS.jpg

rbforums.org

think it should be same as n62/z32 wiring, cause I dont remember a lot of people wiring in n60 MAFS that often.
Modified by placham at 6:15 AM 8/25/2009

[90240sxca18]

That all makes since, But... BUTT my problem is.... the wires on my engine harness are.... a grey wire (black and white tied together into one wire =grey wire) and a torqoise/greenish wire, and a yellow wire.. Thats is... am i missing something here?? or am i just that stupid that i cannot figure this out.