my rb 25 stalls out....

[stlthftr1]

ok so i was just sitting around the house and i decided to work on my car, i had been wanting to move the intake a bit further back to not have the air filter resting on the radiator , so i cut the rubber intake piece before the turbo and after the maf, hooked verything back up as well as it should be and now once the car is at o/t it dies ,it stumbles when slowing down/stopping, and i'm sure there are no leaks. i'm a tech in training and i'm scratching my head at this .... any input ? ideas? help....me please!!!!

[blurrbosi]

clean the maf... mabye check the plug again....

[Coolwhip]

recheck for any leaks behind the MAF. Gotta be something you touched if it wasen't doing that before.

Just like blurrbosi said...check wires to the maf and around it, as well as any vaccume hoses that might of came off or misrouted.

[midnightsliding]

maybe you MAFs is too close to the compressor inlet.

[stlthftr1]

ok, i dunno i got tired and i put things as close to the way they were as possible and i runs fine now,i'm stumped!