Well, after looking around for a while, I found a deal on a 74 620 pickup this past Sunday. I managed to buy at $300 which was a great price compared to other models in the area that were in worse condition.
Little bit of history, the truck's original owner was Alan Jackson, the country singer. He delt in the car trade a while ago and the first buyer (who I spoke with), knew Alan really well and ended up trading a ford double cab for the truck back in 74 because of the gas crunch. From there it was sold twice more, but to people living within a mile of each other (all good friends or relatives).
Anyway, it was a daily driver until about three months ago when the last owner bought a new jeep to drive. It was about to sit for a while until my girlfriend's dad asked her if she would sell it.
So, long story short, I end up with the truck which runs like a top and has very little overall rust. There are a few small holes in the floor pans and the front left has been hit but nothing major. I just need to pick up a few body panels to get the restore on it's way. Here are a few pics:
[IMG]
http://i3.photobucket.com/albums/y79/cy ... truck1.jpg[/IMG]
[IMG]
http://i3.photobucket.com/albums/y79/cy ... truck2.jpg[/IMG]
[IMG]
http://i3.photobucket.com/albums/y79/cy ... truck3.jpg[/IMG]
The interior is probably one of the nicest unrestored interiors I saw while shopping around for these. It had dealer installed air (hanging down), which blows fine but the compressor pump is not connected so I'm not sure if it needs a recharge or works completely.
[IMG]
http://i3.photobucket.com/albums/y79/cy ... truck4.jpg[/IMG]
The egine is good, but I need a gasket kit for the darn thing as it's leaking oil from every seam. The engine was replaced once and has 66k miles on it. They reset the Odometer with the new engine. Also, the carb is running super rich and just dumping fuel. I ended up using 1/4 tank just to make the 30 mile drive home. I'll be looking into webers on the rebuild.
[IMG]
http://i3.photobucket.com/albums/y79/cy ... truck5.jpg[/IMG]
So far nothing amazing but a good platform to begin on. I don't plan on doing a show restore, but I'd like to build it back into a reliable truck that I don't have to worry about breakdowns or rust problems with so I'll be taking it down to the frame and starting from there.
Any pointers or tips would be greatly appreciated.