mines ecu

Post by **redamnavit** » Mon May 17, 2004 1:50 pm

I hear the name Mines tossed around like its Xerox or Scotch. I gather that its a japanese tuner-chipped ecu, and therefore should have a removable socket ROM. Is there anything more specific anyone can tell me? Is it a set tune or is there little guarantee that one ECU will have the same program as the next?

Thanks.

Post by **biosehnsucht** » Mon May 17, 2004 1:50 pm

Not sure if they're socketed, but if you don't have the exact set of upgrades its meant for, its a waste.

Mine's makes good stuff, but its so specifically good that without the same setup you might as well spend your money on having someone else chip it and burn a rom for you.

Post by **float_6969** » Mon May 17, 2004 1:50 pm

:withstup and from what I've seen, Mines doesn't socket them, and they also put a bunch of wax on the chip so that you can't readily remove it. I could be wrong about the socket, as I've never had one in my hands, but I've seen pics of them opened up, and it didn't look like it. But as He said, if you don't have the EXACT setup that the ROM was tuned for, you might as well not bother.

Post by **slw240sx** » Mon May 17, 2004 1:50 pm

waste o money.

Post by **Nismo1182** » Mon May 17, 2004 1:50 pm

I have a Mines ecu for sale. As far as I know, there is no speed, rev or boost limit. Plus its a little tuned for higher boost.

I didnt see a socket in there when I opened it up either.

Post by **mulletmrt** » Mon May 17, 2004 1:50 pm

I wouldn't think it would be in Mines best intrest to socket all of there ICs. That would make it easy for the demand to be on the chips, instead of on the ecus. I think that they would be losing money wouldn't they? But they might be nice, but I doubt it. but I could be wrong.

Mike

Post by **GTR Shop** » Mon May 17, 2004 1:50 pm

on the mines chip i have they set the rev limit to 12,500rpm

so don't go trying to find it...apart from that it pretty much just runs more timing than stock.

Post by **sr20det** » Mon May 17, 2004 1:50 pm

i got an mines ecu and i was wondering if i can chop off the daugther broad from the original mines ecu and replace it with my s13 black tope ecu ? the original mines ecu is burn. the mines ecu is for s13 black top too. have any one ever dones this before ?thx.

Post by **91rs13** » Mon May 17, 2004 1:50 pm

Is there a way to find out what the Mines ECU is tuned for? Or can it be sent back to them to be re-programmed?

Here is there site--but even babelfish will not translate all of ithttp://www.mines-wave.com/

Post by **sr20det** » Mon May 17, 2004 1:50 pm

like i can read "fsdsla;fkdsladfsjlakdjfls"

Post by **91rs13** » Mon May 17, 2004 1:50 pm

Sorry about that--my post was part question and the link

go herehttp://babelfish.altavista.com/

paste in the mines url http://www.mines-wave.com/--use the drop down and ask for japanese to english

mines ecu

mines ecu

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums