Low compression #'s for cold motor

[rn240sx]

So my nephew severely overheated his 2000 altima to the point where the head is badly warped and put a hairline crack in the cylinder wall…
I found a junk yard motor, the ONLY motor i could find locally, and compression tested it COLD with a battery and starter, got 120, 120, 110, 110… Obviously the important thing is that they are the same which is GOOD but the question is, for a cold motor, is this ok..?? Its not going to be boosted at all, just a normal daily driven car… Is this motor in good condition..??

[Infinitiguy19]

Minimum assuming the engine is warmed up is 149 PSI at 300 RPM's (Starter turning the engine at 300 RPM's.) The standard is 178PSI/300RPM's. So I would say it may burn a little bit of oil but it should be fine.