loctite

ONLY for ADVANCED technical discussion about the 240sx!
User avatar
pitchlock
Posts: 102
Joined: Thu Nov 20, 2003 3:45 pm
Car: 90 240sx fastback (rip 3/25/08) and
1993 fastback trackcar
1991 coupe (wife's car)
1974 datsun 260z
Location: Greenville SC

Post

Quick question. I just finished doing a timing chain change on my car. I was thinking before I put the front cover on that I didn't use loctite on any of the bolts for the tensioner or guide. Should I before I put it all back together?


User avatar
1991S13
Posts: 1230
Joined: Fri Nov 19, 2004 5:59 pm
Car: '91 240sx Coupe, '00 QX4 4x4, '02 Sentra Spec V
Contact:

Post

It's a good idea, you can get away without it though.

I Antisiezed everything just because pretty much all of the bolts holding my valve cover down were stripped out.

navysnail
Posts: 3335
Joined: Wed Feb 11, 2004 1:33 pm
Car: 1990 Nissan 240SX fastback

Post

im not sure if the fsm says to, but from what i remember your not. there is no free lunch, loctite will hold bolts in but can make them very difficult if not impossible to remove again without heating them up

User avatar
pitchlock
Posts: 102
Joined: Thu Nov 20, 2003 3:45 pm
Car: 90 240sx fastback (rip 3/25/08) and
1993 fastback trackcar
1991 coupe (wife's car)
1974 datsun 260z
Location: Greenville SC

Post

thanks guys, I put it back together anyway without it but I was just wondering


Return to “240SX Technical Forum”