Larger injectors for the RB25

[jrd450r]

Does any one have a list of some sort or an idea of injectors that came off of other cars that will fit on the rb25 and what their flow rate is? I heard that the supra and rx-7 ones do is this correct? Is there specific models and years that they have to be off of? Thanks!

[eh?]

Just buy my injectors

[virus77]

Im running 05 USDM subaru sti injectors.... 525cc

[jrd450r]

Wa

Im running 05 USDM subaru sti injectors.... 525cc

I have heard of running these, what kind of tuning system are you using to control them? did you have to add a resistor to them? And what kind of HP are you able to make with them before they start maxing out. Sorry for all the questions i am just trying to figure out what exactly I need to get to I can get the project install goin.

[l0nestar]

Im running 05 USDM subaru sti injectors.... 525cc

Direct drop-in replacements.STi "Yellow's" I considered installing these while I had my rail apart.

[virus77]

I'm running a nistune ecu, no resistors needed they are a direct drop in, you have to shave the clip area on the injectors a bit and the stock RB injector clips fit. They should be good for 400whp depending on fuel pressure.

[jrd450r]

I thought that the nistune was not available for the RB25? I looked on their web site and it says that it is in development. How are you running it?

[virus77]

I'm running a z32 300zx which i repined for use on my rb25. They share the same ecu connector but 6 or so wires need to be relocated. You lose one of the knock sensors (my knock maps are disabled anyways) but you retain VTC so I'm happy.

[l0nestar]

I'm running a z32 300zx which i repined for use on my rb25. They share the same ecu connector but 6 or so wires need to be relocated. You lose one of the knock sensors (my knock maps are disabled anyways) but you retain VTC so I'm happy.

Exactly. NisTune Type 2 board. BAM!

[DETurbine]

if you get a top feed fuel rail a cheap ugrade for injectors are oem wrx injectors.....can cut the tip of and get a consistent 800cc.

[Kyle Basbous]

The rx7 GXL 1988-1991 runs 550cc injector's there plug&play you don't need resistors. They plug straight into the stock injector clips with no modification. I use a rb20 ecm with a romtune.