key lock disabling?

[Drill_Sergeant]

is there any way to disable the key lock?

or if you help me on this one...

i installed a turbo timer on my 89 240sx. it was an auto but is now a manual. after installing my timer, i found out i cannot take out my key while the timer is counting down. the key lock will open and give me my key once it finishes counting down or i manually turn off the timer. so i need some help with that.

its a blitz turbo timer. i talked to blitz and the dood wasnt of much help.

[NISTECH]

yes you can disable the key lock. Remove the steering coloum covers behind the steering wheel. on the side of the ignition switch is a solonoid near where the key goes in. Remove the solonoid from the key cyl. That should eliminate it.

[Drill_Sergeant]

cool thanks. i should have done that. i tapped the wrong wire into connector E106 i believe for key/shift lock and i think i may have shorted out the timer.

blows.

anyhoos the timer was always on and kept my accessories on all the time. so finally i disconnected the timer and now all my accessories work normally.

what kind of continuity am i supposed to have between power and ground? they should be open amongst each other is what i though. my meter is reading 19 - 21 ohms. does this indicate something is wrong?

im not too worried about it. i could always get another timer. i only paid $30 for the timer from ebay. but i shure wish i could put that $30 into another timer.

[NISTECH]

you will have resistance through the timer but not to the battery or the ground wire. I am not sure what exactly your doing when you say "between power and ground"

[Drill_Sergeant]

its all good. im not worried about that anymore. i'll just get a new timer and disable the key lock.

thanks for the info super moderator.