Ka24de wiring harness connectors, need some help

Post by **DannyP240** » Thu Jul 02, 2009 5:32 am

Hey guys, im currently removing my KA from my 91 240. Everything is going good with the removal so far, but when i finished taking out the wiring harness i noticed that 2 of the connectors were looking pretty ruff. Theres where these two little black ones that had this sticky build up in them and they kinda looked as if they were burned out too. I was wondering if i can replace just the 2 connectors so i can use the harness for the motor in a different car in the future . the rest of the harness looks good but if i can change these 2 crappy looking connectors it would help me out a lot. where can i get these connectors so i can change them out?

heres looking at it head on

and this is it from the side

Post by **holycrapitsJR** » Mon Jul 06, 2009 6:16 am

Mine has that same plug that looks like that. I think it is a factory delete, I cannot find where it even plugs into

Post by **DannyP240** » Mon Jul 06, 2009 6:20 am

yeah i dont remember where it goes right now but i have the diagram for wiring, but im trying to know where i can get the connector to replace it on my harness

Post by **DannyP240** » Mon Jul 06, 2009 6:27 am

Hey guys, im currently removing my KA from my 91 240. Everything is going good with the removal so far, but when i finished taking out the wiring harness i noticed that 2 of the connectors were looking pretty ruff. Theres where these two little black ones that had this sticky build up in them and they kinda looked as if they were burned out too. I was wondering if i can replace just the 2 connectors so i can use the harness for the motor in a different car in the future . the rest of the harness looks good but if i can change these 2 crappy looking connectors it would help me out a lot. where can i get these connectors so i can change them out?

this is it from head onthis is it from the side

Post by **greencar** » Wed Sep 16, 2009 6:52 pm

It sort of looks like the connector for the gauge temperature sensor. I dunno if that helps

Post by **VRoy** » Fri Sep 18, 2009 8:33 am

The gauge temp sensor sounds right, and another one like that goes to a spot on your coil. all the ones i have seen look rough but work.

Post by **greencar** » Thu Sep 24, 2009 8:14 pm

or TPS?

Post by **nismodrift90** » Thu Dec 10, 2009 1:41 pm

um its the ground for the coil wire just snip it and put a female on the end

Post by **shadowhaven** » Sat Jan 07, 2012 9:16 am

Looks like the temperature switch connector to me.