ka24de slave cylinder = rb20det slave cylinder?

[eLEmEnT]

Simple question.

I need to replace the slave cylinder on my rb20 transmission. Will a slave cylinder from a ka24de (s13) fit directly on? Or do I need a vg30de one or what.

I searched for this on the boards, and got 2 results, I dont think it had a definate answer though.

Thanks in advance.

[themadscientist]

what's the cy;inder bore on the one you want to use? I't a fraction cast into the cylinder.

[eLEmEnT]

your reply was over my head, no idea what you asked.

[SeVa-S13]

There's a size of the bore of your slave cylinder, just like an engine cylinder, it's the area across...

But that's besides the point. Yes, the stock 240 slaves will work on the RB20 transmission. I've gone through 4. (They're the same transmission. )

[themadscientist]

I need to proofread my posts or stop freebasing coffee beans, sorry bout that. I mix and match slaves all the time, you should be fine.

[Joe]

ill verify too, 240 slave will work on the RB20's.

[eLEmEnT]

Thanks a lot guys.

[BoostFab]

Simple question.

I need to replace the slave cylinder on my rb20 transmission. Will a slave cylinder from a ka24de (s13) fit directly on? Or do I need a vg30de one or what.

I searched for this on the boards, and got 2 results, I dont think it had a definate answer though.

Thanks in advance.

i can confirm. i'm using the ka on my rb20 right now. the ka transmission slave cylinder is the same as the rb20...email me if you need one, i have an extra rb20's. or you can get one at the local auto parts store (autozone, oreilly, etc...) just ask for the 240sx's.

[s14-240]

Well, yeah the internals of the transmission are the same, but the bell housings are different, and when I compared my ka cylinder to the rb's, they had one difference. The length of the rod is the same, and the cylinders work in the exact same fassion, but the ka's cylinder mounts out a little farther than the 20's, causing the rod to by a little skewed. It's not really a problem though, just use a ka one.

[Nameless EJ6]

Now can anyone verify if it'll work on the RB25 box?

[gawdzilla]

want to know too....what slave cylinders work with the RB25 trans?

[RBpoweredSileighty]

thats cool, so the stock KA slave will work on the RB20DET transmission...

[accel junky]

I have the KA on the Rb20 trans (rb25 engine...long story) and it bolts on but the rod is skewed. Don't know if thats a bad thing, but I was too lazy to swap them out, because I didnt want to do any bleeding. Don't know if it works or not yet.

[dareo]

I've got a 240sx spec slave cylinder from autozone even working great on my RB20DET trans. It just bolts on and pushes the clutch fork, it never knows the difference.