KA24DE ITB MANIFOLD "HELP PLZ"

[r3d47]

I need to know a website or a place of somekind that sells a ITB MANIFOLD or a aftermarket manifold for the KA. I have had people tell me that there is tons Im just kinda lost without a name of a place or a website or a custom shop.

[mkory]

No sir... IIRC there have only been a handful of intake manifolds made for the KA, and all of the ITB ones are a custom job. You could always take a hacksaw to yours, and connect it to ITBs from a bike.

[fonebooth]

Nissan Comp is currently in production of a DCOE type intake for the KA DE(as they already have it for the E)

this will come in 2 parts (afaik) and you can use either a ITB, or a Jenvey or TWM throttle body setup or then custom make a plenum

[ShionS14]

I have never heard of Nissan Comp? do they have a website?

[deviousKA]

There is a dcoe-type manifold manufactured by Ed Pink that some might call a "nissan comp" (nissan motorsports USA) manifold, as it is used by the nismo team ka24de's themselves.

But as far as I know they havent started casting them for mass production. BC Gerolamy did the ones for the sohc sold through nissan motorsports.

Ed Pink is a master nissan engine builder, almost humorous really that he is the one that prepared the ka24de for race use in the nissan sponsored corr series.

Your not going to get a chance to get a new one direct from the source, but you could try getting one used from rebello, they probably have a couple kicking around.

Or just make your own, Troy Ermish (datsun 510 outlet) has made a couple, a good example. He may also be able to sell/source you a part individually, I am not sure.

[Bigvinnie]

Your not going to get a chance to get a new one direct from the source, but you could try getting one used from rebello, they probably have a couple kicking around.

I believe this is true. I have seen a few of these on Rebello's engines. From my knowledge Rebello engineers some of the GT3 class engines as well.