KA needs help

Got questions about your Nissan? We're here to help, and it's FREE!
scott
Posts: 56
Joined: Sat Apr 05, 2003 11:50 am
Car: 89 350 S-10, 1970 PONTIAC LEMANS

Post

i have a 93 240sx with 110,000 miles. it misfires alot and the revs dip way down when i push in the clutch coming up to a stop sign. somtimes the car actually dies coming to a stop. the car surges a little and just doesnt have near the horsepower it did when i first bought it. there is not a check engine light on. i have put on plug wires, plugs, fuel filter, air filter, o2 sensor, coil, cap but not rotor button until tuesday, cleaned AIV valve, and ran fuel system cleaner in it several times. i did have a couple vacuum leaks but i fixed them over the weekend. i cant think of anything else to replace and need help.


drjohn
Posts: 415
Joined: Sun May 05, 2002 3:27 pm

Post

Check the coolant temp sensor for corrotion.

User avatar
Importroller
Posts: 1135
Joined: Sat Oct 26, 2002 10:12 am
Car: G35 and 07 Altima 3.5 6spd
Location: san diego
Contact:

Post

you check your MAF?

WorkinDriver
Posts: 37
Joined: Thu Apr 17, 2003 5:20 am
Car: 240's

Post

I had the same prob.. On 91....w/ 89,000...It was the temp sensor..

User avatar
Rev_D21
Posts: 5946
Joined: Sun Jan 12, 2003 9:49 pm
Car: 1986.5 D21 LB HD 2WD V6 5Speed
1991 D21 Reg 2WD Auto
1995 D21 Reg 2WD 5Spd
1996 D21 Reg 4WD 5Spd
2012 Versa 1.6S 5-Speed
Location: Somwhere in Western NY
Contact:

Post

Also check and test your IACV/AACV Idle Air Control Valve/ Auxilary Air Control Valve. Those go bad a lot and can make for a poor idle and a rough engine off idle. Also check the EGR valve to make sure it's not stuck in the open position. That will cause a very rough idle.

scott
Posts: 56
Joined: Sat Apr 05, 2003 11:50 am
Car: 89 350 S-10, 1970 PONTIAC LEMANS

Post

i have messed around with my temp sensor when i installed a resistor i bought off of ebay that was suppose to increase horsepower. but that was a rip off because it flooded my car out so it would die and wouldnt start. i had these problems before i installed this piece. the MAF sensor i tried using a friends MAF sensor and still had the same problem. he has a 92 240sx. i'm not too sure about the valves your talking about.

NiTeRiDeR
Posts: 94
Joined: Thu Apr 03, 2003 3:21 am
Car: Z32 + D21 + 2x R32
Contact:

Post

just take off every valve that has to do with ur intake and clean it with air intake system cleaner (cleans throttle bodies, etc..) or if you dont have that... use carb cleaner...

spray some into ur throttle body (you might have to spray in thru the intake right above the filter since if your car is anythign like mine... it wont run well without the MAF

your car will sound like its going to die... but it helps clean your engine out...

coolant temp sensor.. PCV valve ... O2 sensor... check those too

there is a thread just below stating the location of those 3 items i believe

EDIT: oh and by the way... never believe what people tell you on EBAY

Trppen37
Posts: 264
Joined: Fri Feb 28, 2003 4:03 pm
Car: CA18DET
Contact:

Post

where can you purchase the coolant temp sensor pcv valve and o2 sensor??i kno for sure u can purchase the o2 from PDM but they also dont have coolant tempsensor nor pcv valve..

U12 2NR
Posts: 367
Joined: Sat Mar 22, 2003 4:29 am

Post



Return to “Nissan Online Mechanic”