KA Cutting out Under Full Throttle

ONLY for ADVANCED technical discussion about the 240sx!
Blown240sx
Posts: 1963
Joined: Thu Apr 21, 2005 3:20 pm
Car: 1996 240sx

Post

I dont know if this has been posted before and Ive searched but the search doesnt like specific wording.

I have two friends cars doing this and I dont have any ideas of what they could be.

We have replaced MAFECUTPSHarnessDistributorChecked all pipes for leaks

The car will rev all the way to red line in N or under load @ 50% throttle or less but if you go over 60-70% throttle the car cuts out horribly and stutters like a 2 step.

This has to be some what common if two of my friends cars are doing the exact same thing.


User avatar
locoluna825
Posts: 862
Joined: Fri Mar 28, 2008 12:09 pm
Car: 90 240sx coupe

Post

go outisde while its dark, turn the car on, leave the lights off, open the hood, and stare at your engine for a while. Now let your eyes adjust, see if you can spot any little flashes of light goin off around the plug wires.

del82
Posts: 124
Joined: Tue Dec 30, 2008 8:15 am

Post

Easier than that, just get a spray bottle full of water and wet down the wires, and drive it again, if it's the wires the motor will stumble hard.

User avatar
locoluna825
Posts: 862
Joined: Fri Mar 28, 2008 12:09 pm
Car: 90 240sx coupe

Post

yea... but my method doesnt include driving the car :D you can do it form home lol. Ive recently bought 2 sets of plug wires from kragens and they were 5 mm and 7mm wires, a month after installed them both cars were missing under loads up hills and such.

I went out one night to see what was goin on so i took a look at them in the dark and they were arcing like hell on everything I fixed one of them temporarly but the damn V8 just has to many wires to move around. Im gonna take them off and go back and throw them in there face then get some 8mm ones from napa.

Blown240sx
Posts: 1963
Joined: Thu Apr 21, 2005 3:20 pm
Car: 1996 240sx

Post

Wouldn't the car cut when under partial load also? This car cuts under no load in neutral free revving. If its half throttle or less car runs to red line no issues. If you mat the gas though car cuts out horribly.

Vegascorbin
Posts: 732
Joined: Sat Nov 24, 2007 9:56 am
Car: 1990 240sx dirt track race car

Post

Does this thread match what you are trying to say?

zer...d-gov

Read it over and let me know.

the_stig_of_drift
Posts: 3
Joined: Thu Jan 15, 2009 2:48 pm
Car: 1991 s13
Contact:

Post

i have the same problem including if i hit the gas up to 50% it runs fine and shifts hard, but anthing above that it feels like the car just revs to where it would at full throttle but it doesnt have the same power only to 4 grand on the tach then the power drops off and starts cutting out a little wtf? i guess i should post this but i dont know how newbie to this not a newbie to driving lol this is my second motor so i swapped all the sensors from my old engine and its still doing it

Blown240sx
Posts: 1963
Joined: Thu Apr 21, 2005 3:20 pm
Car: 1996 240sx

Post

sounds close to the same but not exact.

alright read this carefully

Car will rev to red line in any gear and in neutral as long as you dont exceed 50% throttle.

Car will cut out in any gear including neutral if the throttle is pressed more than 50%.

New plug wires were put on with no change.

We checked grounding and all the ground seem to be fine. the motor has 6 points of ground now

Guess we will keep trying stuff.

maniacman9558
Posts: 71
Joined: Sat Aug 01, 2009 2:50 pm
Car: 93 240sx n/a KADE (for now! =P)
05 ninja zx10r
Location: lancaster, PA

Post

hey im having the exact same problem with mine so if you figure it out can you please let me know? i will do the same for you if i figure it out. thanks!


Return to “240SX Technical Forum”