KA clutch in CA

[Bryson]

Hey everyone,

My clutch is just about shot on my KA.

I am swapping my CA in this summer after I get the money for a few remaining parts, but my cluth in my KA isn't gonna make it that long.

I was wondering which KA clutch will work with the CA transmission/flywheel.

Will the ACT NX4-HDSS Street Clutch for $300 at enjuku work? I am asking because I remember reading somewhere that one company will fit, and another will not.

Any help would be appreciated.

[themadscientist]

as long as the diameter of the friction surface is the same, 240mm if memory serves and the spline count is the same it should drop right in.

[mambastu]

The CA uses a 225mm clutch.

I'd be interested to know what KA clutches fit as we only really have the Jap units available over here in the UK and they're bloody expensive

[themadscientist]

what manufacturers are available at your auto parts store. Here I see exedy and parrut, do you get those? I could probably look the number up.

[paul_s13]

what manufacturers are available at your auto parts store. Here I see exedy and parrut, do you get those? I could probably look the number up.

Nope we don't get any of those makes.

We get LUK, Helix, AP, Borg & Beck.

[Bryson]

Well the ACT clutch is 225 MM according to their site so I suppose it should fit then. I have read something about needing to dremel either the housing or a part of the clutch to make it fit.. I am not sure exactly what part of either this is that would need to be dremeled.