junkyard motor

[1995240sxSE]

Just curious after I have beatin on my resurected kat what my compression was and 180 180 180 180 on a motor that sat in a junkyard for 3 yrs out of a 1991 hb. I was very impressed!!!! I was afraid to even check before I put it in to my car. It only had 105K on it and that thang is factory specs, lucky parts car find! BTW anyone looking for some parts I will pull and all u gotta do is pay for shipping! only 10 days till I move!

[Florida240sx]

You mean you put a used engine in your car without checking compression??? wow that is brave. I didn't check mine but it came from a running vehicle 5months prior.

[Chezedik]

You cannot accurately check compression without running it. But I could use the shifter console and radio bracket with pocket. Then, I need door panels, a radio harness cut, and a built KA-t ready to drop in. Other than the KA-t, can you help?

[Florida240sx]

Yea but you could tell if there was a blown HG.

[1995240sxSE]

I took the head off of my motor and put it on the junkyard short block, replaced the headgasket in the process! I think I can get you the door panels if you want them. And possibly the radio harness. How much you wanna pay for the kat ready to drop in, I could pull mine???!!! for the right price!

[Chezedik]

I am sure it is more money than I have. What do you think about the other parts? Can you do the center console section?

[TheOne]

does it happen to have a lsd rearend?

i bought a junkjard engine with a bunch of miles and no compression testing, but i however rebuilt the engine right after i bought it.

[1995240sxSE]

if that bich had lsd It would be on my car!!!!!!! the center console is not there sorry! and I used the inner shift boot for my 5 speed swap. There is a dash in it tho

[Chezedik]

What about the bracketry for the tape deck, and the reverse harness?

[1995240sxSE]

I think the bracket is in there, the reverse harness I am pretty sure came out when I pulled the transmission for my 5 speed swap, describe it a bit and I will check.

[1995240sxSE]

also the 5 speed ecu should be fine?????? any takers I am leaving nc and this parts car soon. I have the cams from the 91 de laying around too. And also the 91 head is around, minus the cams.

[Luderacer14]

Hey, whats up. I had no clue there was another ka-t around. You should drop by, i'm at the MCAS New River. I just upgraded my setup again and car won't idle.