Jarco has 3 CA18 clips

[Onizuka]

Just though i would give you guys a heads up on 3 manual CA18DET clips on there way to jarco in georgia. Hope some niconauts pick em up

[Nismo1182]

A friend of mine also has a CA clip hes trying to sell here in Orlando. Im going to check it out next week and let you all know how it is.

[NeedCAforS13]

JARCO ROCKS! I've got alot of MR2 friends who get their stuff from them (as well as J-spec Tuner's Silvia front end :pface ) and all their stuff is always top notch quality... they haven't ever dealt with CA's in the past, but 3 clips coming means someone there is starting to listen:)...

Sean

[PacManVR4]

They have had 1 ca clip before. I asked them about getting one back before I bought my motor and they said the CA was to hard to find most of the time. Jarco is top notch and I would recomend them to anyone. Their prices might be kinda high but they are honest about stuff.

[Onizuka]

The best part about jarco, if your clip happens to have forged internals, top mount turbo, cams, coilovers, big breaks and a standalone engine managment on there, they leave it and you get all the loot. :ylsuper

EDIT: and yeah, i have seen ca clips there before but this is very unusual having 3 at once.

[Kenji180]

I'm planning on getting one of those clips on Sunday.. Gonna drive up there to pick it up!

:ylsuper

[nab911]

they are like right next door to me and i have heard a lot of good stuff about em. I got my motor from JHOT and they are about 3 hours east of jarco but they are about the same way. 2 of the clips are autos so think about the conversion costs as wel (transmission, and if im correct... ecu)

[Kenji180]

how much are the clips over there? I may have to check them out as well..

[nab911]

they only sell motorsets but mine included everything plus smic and full piping.. i ended up paying 1450 for the full motorset and just picked it up. I think they only sell their motors off ebays just look for em under jhot_exports. One of their rb20 motorsets went last night for 860...

[PacManVR4]

http://www.jarcoinc.com or ebay id jarcocorp

[Nismo1182]

Kenji, a friend of mine told me theres a CA clip in Orlando. If your interested, let me know.

[float_6969]

I wanted to get mine from there, but they said they were too hard to get. I wish I would have waited. I wouln't be rebuilding the motor if I had...

[Kenji180]

I may be interested Nismo1182, can you get some pics/info to me at [email protected] ?.. I just found out Jarco won't be getting the clips until sometime in March.. I will probably go with that, but it's an auto.. He's giving me a 5-speed -ET or -E transmission with it, but I don't really want to use that.. plus I got to get a clutch/flywheel too.. I just want to save money any where I can, cause I have to pay for school as well..

[Nismo1182]

I'll get you info on it soon. Im going to take a look at it sometime next week and post the info up on here for my friend.

I do know this clip is a 5 spd

[Kenji180]

Thanks man.. I would appreciate it!

[Nismo1182]

You going to the drift event tomorrow? Sean and I will be there.

[float_6969]

I wish i lived in florida...