First post here - thanks for approving my account.

Is there a diagram somewhere of the underbody jack points where a floor jack can be used? The manual only mentions pinch welds.

I’ve been using my floor jack and jack stands to do oil changes for the past 9 mos or so, but the pinch welds are starting to separate on one side and I’m concerned that the center front crossmember I‘ve been using is bending the frame.

Thanks!

See page GI-30:
https://www.nicoclub.com/service-manual ... 3%2FGI.pdf

Oh, fantastic! Thank you VStar650CL. I’m encouraged to learn that I was in fact using the correct jack points front and rear.