installing remote starter help??

General discussion forum about the 240sx, and a great place to introduce yourself to the board!
osofasts13
Posts: 67
Joined: Wed Dec 03, 2003 3:37 pm

Post

okay i was wondering, can you install a remote starter on a manual car?? the booklet that comes with the kit says that the kit is made for automatics only, but i have seen many manual cars with remote starters, sentra's too. so my question is can it be done and how?? from my understanding the whole stepping on the clutch idea to start a manual car was a safety theory. (so car won't leap and stall if car is started and is in gear) but can't you bypass the switch that tells the car that the clutch is being stepped on?? from what i have observed the 91-94 240sx have a little switch at the bottom of the clutch, and when you step on the clutch it just depresses this switch to start the car. if you press the switch with your own hand, the car will start. so just bypass this switch right?? please enlighten me car GODS, for i have sinned (well by not knowing this). this was a gift from my wife for my B-DAY today, so all, please help, and it would be helpful to have the car warm and all when you go in because of this freeezing michigan weather.

------------------------------


IvoryJ30t
Posts: 3076
Joined: Sun Aug 17, 2003 1:36 pm
Car: 95 Maxima GLE, 95 Maxima GXE

Post

absolutely. just get a fsm, and dont be afraid of electricity.

the switch is just a safety mechanism.

User avatar
Camel
Posts: 1141
Joined: Tue Jul 08, 2003 2:43 am
Car: That would be obvious....

Post

Don't even bother with the switch, it is not necessary. When you wire the start wire it should be 10 gauge and run all the way to the starter solenoid. At that point you have bypassed the switch. Make sure that you teach yourself to leave it out of gear. As you'll see in my sig, I had one in my 91. Make all of your other connections in the ign harness on the column. Solder all the connections, because you definately don't want splices to break. NEVER CUT the wires, peel back a little insulation with a razor blade and poke a hole through the middle of the strands, push through then wrap around and solder. Tape when cooled.

I have one for sale if anyone wants it - Older Code Alarm Remote Start (Maybe i should post in the b\s\t with it.).

I have the wiring designations for the 98 if anyone needs to do an alarm or remote start, etc...


Return to “240sx General Discussion”