Installing Greddy PRofec B-Spec-2 Boost Controller Help PLZ!

[maxZpak]

Hey guys i have a this Greddy PRofec B-Spec-2 Boost Controller installed in my car but the valve unit is not connected to the wastegate or anything can some1 send me some help or a step by step install on the valve unit i already have it connected to the boost controller with the harness all i need is the waste gate installation on where it is and where the hoses go etc... PLZ HELP!

[fregisr]

disconnect the hose that is going in to your wastegate and plug it in the common in the solenoid. Now plug a new hose from NO port of your solenoid and the other end of it to your wastegate

[gpelite]

I could tell you the whole process, or I could give you a forum that has done it already with pictures. If you'd like to explain I could, but here is the site lol

http://www.thumper300zx.com/z3...b.htm

Enjoy, its quite nice

[greatgonzer]

Nice write ups. I orginally had a Greddy Spec II boost controller, But several Z owners told me to get rid of it. A whole host of people told me that they were problematic with the Z32. So I sold mine and purchased a Greddy Type S boost controller instead... Anyone else have problems with the Greddy Spec II?

[maxZpak]

thanks a lot! Ill try to follow if run into any problems I'll ask you more.

[maxZpak]

what kinda problems do people run into with these boost conrollers?

[gpelite]

I really don't know what they experience, I have not heard of problems with it personally. I have seen a few magazines do write ups with the unit, but then again money pays for products being used to be publicized. I am curious whats wrong with them as well