Questions about Installing BOV And Boost Controller in TT

[Gammaray6666]

Hi i was hoping to find some information on here to install a BOV('s) and boost controller on my TT, i have everything set up and i just need to know if i cap off all my solenoid's/remove them or just specific ones, also i have the vacuums set up except for the BOV i need to know where they go too. i have researched this topic extensively and can seem to find a straight answer that applies to my situation. if there is already a post on this plz redirect me to the information.

thanx in advance sorry for my typing mistakes

[Gammaray6666]

OK so i Just went at it the same day and figured it out using a Stock diagram. i later found a great guide!!! here is a link to
http://z32.wikispaces.com/ A Z32 wiki (DUh)

and the diagram i used
http://z32.wikispaces.com/file/view/TT_ ... roller.png

So i used that last diagram and then replaced the re-circulation Valves with BOV's

Not to mention i have no more boost leaks!!

[Gammaray6666]

OK so i Just went at it the same day and figured it out using a Stock diagram. i later found a great guide!!! here is a link to
http://z32.wikispaces.com/ A Z32 wiki (DUh)

and the diagram i used
http://z32.wikispaces.com/file/view/TT_ ... roller.png

So i used that last diagram and then replaced the re-circulation Valves with BOV's

HOPE THIS HELPS SOME PPL

[300ZXttZMAN]

Welcome to Nico!

Thanks for posting the result!