installing a ca, post ka parts.

[kahlistrophic]

Ok, I have searched, i dont know if im not putting in the right key words or something...but when installing a ca into a s13 saying you have the complete engine and head, and harness. What else do you need for your install, in other words what parts that are in the s13 with KA, eg. radiator, hoses, etc. Must be replaced? I know that the trannys can be swapped out, but Id rather try to get the transmission as well. Also, if getting an engine that came from a 180sx, with plans to run stock, what would be good to do to the engine before swapping. Thanks alot, No Flaming please, just exhausted....

[teddy]

Did you read through the sticky's? There's quite a bit of info regarding little things here and there, but I'll try and answer some of your questions.

If you have the complete CA engine and transmission, they will swap right in, meaning you can use the stock ka motor/transmission mounts. The engine will sit a little taller, but still fits without problems. You can buy CA nismo mounts if you want the engine to sit properly. The stock ka driveshaft fits fine too.

You will need to modify the main engine harness and probably the lower chassis harness too, but its not difficult. Check heavy throttle's website for the diy writeup.

Actually, to save me some typing and you some reading, the CA swap is just about identical to an SR swap. Check the sr swap guide on heavy throttle for that writeup too.

Good things to do before dropping the motor include: replacing old coolant lines and vacuum lines. Replacing various gaskets such as valve cover, rear main seal, etc. New water pump, possibly a timing belt. New accessory belts, spark plugs, thermostat. Just very basic things.

[kahlistrophic]

thanks alot man, yeah i have read through the sticky's its just i dont rememebr seeing anything about radiator or driveshaft compatability.

[teddy]

The ka radiator works.