Installed electric fans and now have a ?

General discussion forum about the 240sx, and a great place to introduce yourself to the board!
rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

I installed twin 12" electric fans today with a 185 degree thermostat. It's supposed to kick on at 185 and kick the fans off at 165. Well I let the car idle for 15 minutes, then drove the car, then let it idle for like 5 more minutes. The temp gauge didn't go above the 3rd bar and the fans never turned on. Is the car just not getting up to 185 or did I wire the fans up wrong(and my temp gauge is off)? With the clutch fan the car ran at about the same temp, according to the gauge, as it is now. :confused:


MainEvent212
Posts: 4182
Joined: Tue Mar 04, 2003 1:21 pm
Car: 95 Nissan 240SX SE w/ SR20DET+goodies

Post

well according to the gauge the car didnt get hot enough i guess...lol

rousie13
Posts: 4106
Joined: Fri May 09, 2003 5:55 pm
Car: 2006 Nissan 350z Track Edition, 1997 Ford F250 4X4
Location: Delaware, OH

Post

Well I just found out I didn't wire them right, not a big surprise there. So I have to check the wiring tomorrow or just throw in a relay with a switch.

nrcooled
Posts: 182
Joined: Tue Feb 04, 2003 7:29 am
Car: cars, duh

Post

Quote »just throw in a relay with a switch.[/quote]I tried the trick install and my fan didn't cut on because of a short and I didn't know it because I assumed my engine wasn't running hot enough. So I scrapped all the thermostats and sh1t and just ran a toggle switch in the cabin and turn it on when I get in the car and cut it off when I get out.

If I am on a stretch of highway and doing 80mph I will cut them off but most times I just let it run all the time (twin 12"s)


Return to “240sx General Discussion”