injectors tips..

[turbo2nr]

ok im about to remove the stock 270cc tomorrow and install the msf 52lb top feeds...

any tips and tricks to make this go smoothly? i tested the ohmes its 12-13 on the injectors, those should work fine right?

also for the injector i just "push" them into the top feed fuel rail to, is there any other connections to make them secure so they wont pop out? or does the rubber 0 ring hold them in place?

thanks

[turbo2nr]

no tips and tricks ppl? so it should go smoothly.. its the last step before i dyno...

[hpmachine]

I'm not 100% sure if this is what you are talking about, but there should be brackets holding the rail down to the intake manifold. the o-rings keep the gas from leaking out but they won't hold the rail down. If the rail isn't secured to the manifold somehow, it'll just blow off. If you already know this just slap me

[HaXoRsMoBiLe]

thats really all there is to it, the o rings should seal it, 2 bolts onto the mani...and uhh...good luck!-paul