Injector plug order

[F3600]

Hi everyone im about to have my car completed ! My piping is almost done, i only need a 1 feet piece and everything will be completed ! Today i was removing everything to install my waterpump , thermostat and engine temp sensor. My crank pulley is jammed there i will need to buy a crank pulley puller .. ahh well here my question

on the harness there 4 injector connector ,the 2 in the middle are yellow and green (there a sticker on it) in wich order they connect ?

starting in front of the engine there

small yellow yellow sticker green sticker small yellow

is it alright ? i started my engine the other day without piping the engine was shaking a lot.

anyway any help would be fine Thx

Fred

ps: click on the link on my signature to see my work / progress. its a litlle ghetto but well i dont care

[240 Trainee]

Dude, I wish I could tell you!! I finally figured out hw they went, except, my car is stuck on the side of the road awsy form my house, and I can't look. It isn't that bad, they pretty much go where they should. length of the wire wise. If this makes sense at all.

[F3600]

yeah i plugued it like that but the two one in the middle are kinda the same lenght, i will just switch them and if i see an amelioration its pluggued fine :P

[pulsar gtr]

here are the colors and orders

Injector # 1 the closest to the Cas, white/black white

Injector #2yellow/blackyellow

Injector #3Green/blackgreen

Injector #4blue/blackblue

PULSAR GTRRafi

[F3600]

thx for the info.. i managed to plug my first injectors into my engine temps Sensor.. :\ well i found my shaking problem lol

[Kenji180]

So having the injectors plugged in the wrong order/incorrectly would cause the motor to shake badly?