injector install help

[emperor_lunchbox]

I have some 450cc DMS injectors, I know I need the fuel rail and a resistor box to make the low impedance injectors work, but, does it matter the box. I was either going to buy the resistors from JGS and have to solder them or get one of those boxes from a honda or DSM.I found a box, I was just wondering if it will work.

here is a link:http://cgi.ebay.com/ebaymotors...ZWDVW

[savatoge]

You are wanting to boost a factory NA vehicle. Don't cheap out on the fuel delivery...you want to ensure precise, timely fuel delivery.

Did you get a good deal on the injectors? If so, spend $20 on some resistor packs.

Just my opinion of course.

[emperor_lunchbox]

I got a pretty good deal on the injectors, but I dont want some rigged injector setup costing nearly as much a deatschwerks injectors. The whole point was to save money.

[fiznat]

You can find the DSM resistor boxes pretty cheap, and I know for a fact that they work perfectly. I see them at junkyards all the time, and on ebay going for 20 bucks or something like that. Not sure about that Honda box, never heard of anyone using those before.

[emperor_lunchbox]

so would it be better to get the box or solder the resistors on all the injectors. I am not too good with the soldering iron. but I don't know if I trust myself hacking up injector wires either.

[LEMHEAD16]

I used the CRX injector box and it worked fine. Cost $9 to boot:)