Igitor chip problem

[emo]

i have a problem i was wiring a z32 igniter chip into a sr20 harness but i came across a color difference. on the 7 prong plug that runs the coil pack was ran correctly because the colors matchedI1 = Red/whiteI2=Red/YellowI3=Red/greenI4=Red/blueGroundbut on the 6 prong plug i was supposed to run red/blue on E1, Red/White on E2, Red on E3, and Red/Green on E4 but the colors provided on my harness is a tan looking color,white, red and green. which i have provided in this picture where do they go? i randomly tired to plug them up but didnt think that was the brightest idea
Modified by emo at 7:30 PM 5/7/2008

[Hijacker]

If you're going by the heavy throttle wiring guide, the guide just states what color of the SR harness needs to go to what pin. So make sure that the Red/Blue wire fromyour SR harness goes to E1, the Red/White goes to E2 etc.

The 7 prong plug you have looks like it has the wires done up backwards. The diagrams on HT, and in teh FSM, are usually done up looking into the plug.